AEG BE2003021W - Manual (Page 25)

CARE AND CLEANING
WARNING!
Refer to "Safety information" chapter.
Notes on cleaning:
• Clean the front of the appliance with a soft cloth with warm water and cleaning agent.
• To clean metal surfaces use a usual cleaning agent
• Clean the oven interior after each use. Thus you can remove dirt more easily and it does
not burn on.
• Clean stubborn dirt with a special oven cleaner.
• Clean all oven accessories (with a soft cloth with warm water and cleaning agent) after
each use and let them dry.
• If you have nonstick accessories, do not clean them using an aggressive agents, sharp
edged objects or dishwasher. It can cause a damage to the nonstick coating.
Pyrolytic cleaning
Remove all parts from the oven.
The pyrolytic cleaning procedure cannot start:
• If you do not remove the shelf rails or telescopic shelf runners (if supplied), the clock
display shows 'C1'
• if you do not close the oven door correctly (the clock display shows „C3“) .
1. Remove the worst of the residual dirt manually.
2. Set the Pyrolytic cleaning function (refer to section "Oven functions").
3. When flashes, press or to set the necessary procedure:
– P1 2:15 for a low degree of dirt,
– P2 2:45 for a usual degree of dirt,
After 2 seconds procedure starts.
To change length of selected procedure ( P1 or P2 ), press to set , then press or
to set length for the pyrolytic procedure.
You can use the End function to delay start of the cleaning process.
When the oven reaches pre-set temperature, the door locks. The symbol and the bars of
the heat indicator come up, until the door unlocks again.
During pyrolytic cleaning the lamp is off.
Cleaning reminder
To remind you that the pyrolytic cleaning is necessary the cleaning reminder symbol flashes
in the display PYR after every activating and deactivating the appliance for the next 10
seconds.
The cleaning reminder goes off the display:
• after end of the pyrolytic cleaning function;
• if you use or , when is flashing;
Care and cleaning 25