Initializing the embroidery unit – Brother PC 8500 User Manual
Page 112
1. Turn on the power. The following display will appear on the
LCD.
*
When the buttonhole lever, the needle or the presser foot
lever are lowered or when the bobbin winding shaft is at the
right, an error message will vary depending on which of the
conditions mentioned above is occurring. The display shown
at left will appear after the error condition has been
remedied.
2. Touch the “CHECK” key.
The carriage will move in order to initialize the embroidery
unit.
CAUTION
Do not place your hands near the embroidery arm,
otherwise injury may result. Please note that the
embroidery arm may make an unusual noise while
initialization is being carried out, but this is normal.
If the initialization could not be carried out normally, a
buzzer will sound. If this occurs, make sure that the
embroidery frame is not attached and try again to initialize
the embroidery unit. This is not a malfunction.
The types of patterns available will then be displayed on
the LCD.
1
Alphabetical characters
2
One-point patterns
3
Frame patterns
4
Floral alphabets
5
Patterns found on memory card (optional)
6
Touch to position the embroidery arm for removing unit.
Initializing the embroidery unit
1
2
3
4
5
6
109
(Programmed