Dart seam – Brother PC 8500 User Manual
Page 73
Advertising
70
(Programmed
DART SEAM
1
1. Attach presser foot “J”. Sew a reverse stitch at the
beginning of the dart and then sew from the wide end to the
other end without stretching the fabric.
1
Basting
*
If automatic reinforcement stitching is preset, a
reinforcement stitch will automatically be sewn at the sewing
start.
2. Do not sew a reverse stitch at end. Cut the thread at the end
leaving 5 cm (1-15/16”), and then tie both ends together.
3. Insert the ends of the thread into the dart with a needle.
4. Iron the dart to one side so that it is flat.
J
Advertising