Philips 4 HD S VHS HIFI VCR - Manual (Page 10)

10 Installing/Removing the Lithium Battery
You may install a lithium battery in the VCR. This will allow the
VCR to save the clock setting and the programmed timer
recordings if a power outage occurs. The battery can back up
your timer recordings and clock setting for around six months
(4,000 hours).
Connect the power plug to an AC outlet before installing the
1
Connect the power plug to an AC outlet and turn off the
VCR power.
2
To open the battery compartment, press the cover’s
release tab to the left, then remove the cover.
3
Press a lithium battery into the compartment with the
plus (+) side facing out.
To remove the lithium battery, push the latch A downward using
a pointed, non-metallic object.
4
Replace the battery compartment cover.
Lithium Battery Warning
The lithium battery may present a fire or chemical burn hazard if
mistreated.
CAUTION: Risk of fire, explosion, and burns. Do not recharge,
disassemble, heat above 100°C, or incinerate.
Replace the battery with a Panasonic (Matsushita Electric), Sanyo,
Sony, or Maxell CR2025 only; use of another battery may present
a risk of fire or explosion. To order a new battery, see page 68
(back cover).
• Promptly dispose of used batteries.
• Keep the battery away from children.
• Do not dispose of the battery in a fire.
A
2
3
4