Philips 4 HD S VHS HIFI VCR - Manual (Page 12)

VCR TV
VCR/TV
QUICK PROGRAMMING
POWER
STILL/SLOW
EJECT
CH VOL
EXIT/STATUS
TIMER
JOG/SHTL
SMARTPICTURE INDEX AUDIO/MUTE
MENU
- +
CBL / DBS
1 2 3
4 5 6
7 8 9
START STOP DATE
DBS DAILY
PLAY
REW FF
/OK
STOP
WEEKLY
REV
/OTR REC REC
FWD
-
+
-
+
SPEED 0 CLEAR
5-6
12 Turning on Your VCR (cont’d)
6
Press the FF :/OK button to begin automatic channel setup.
AUTO CH. SET PROCEEDING PLEASE WAIT will appear on the
screen. The VCR will memorize all of the channels you receive, so
when you scan through channels using the CH(annel) 8/9 button,
you’ll only scan through channels that you receive.
7
When channels are set up, AUTO CH. SET COMPLETED will
appear on the screen briefly.
CONNECT ANTENNA OR CABLE
TO VCR
THEN PUSH :/OK KEY
OR . . .
FOR PLAY ONLY – PUSH STOP
• Auto or – – : – – may appear on
the display panel until the clock is
set. After you connect the
antenna/cable signal to the VCR
and connect the VCR to a power
source, the clock may set itself
automatically. The current time may
appear on the VCR display panel.
• If you do not want to set up
channels now, press the STOP 9
button at step 6. TUNER NOT SET
will appear on the screen briefly.
• You may not set up channels at
step 6 if you are using a Cable
Box/DBS.
Helpful Hints
5
If you do not want to set up the Cable Box Controller
now, press the FF :/OK button to leave the Controller
turned OFF. The display shown below will appear on the
screen. Proceed to step 6. You may set up the Controller later
by following the instructions on pages 45-49.
If you do want to set up the Cable Box Controller now,
follow steps 5-8 on pages 46-47.
7 Wait for the VCR to set up
channels.