Philips 4 HD S VHS HIFI VCR - Manual (Page 38)

38 Timer Recording with the VCR Plus+ Programming System
• If you enter an incorrect PlusCode
programming number at step 4,
ERROR-RE-ENTER CODE will flash
on the screen after step 5. Enter the
correct PlusCode programming
number.
Helpful Hint
Follow the steps below to program a timer recording using
PlusCode programming numbers. Before you begin make sure:
• Channels are set up. Details are on pages 13-14.
• The clock is set. Details are on pages 15-19.
• There is a tape in the VCR. Make sure the tape’s record tab is
intact and the tape is long enough to record the program(s).
• The VCR is in VCR position (the VCR light will appear on the
display panel). If the VCR light does not appear, press the VCR/TV
button once.
• You have programmed the VCR Plus+ and Cable/TV channel
numbers. Details are on pages 36-37.
When you use a Cable Box/DBS, timer recordings are
programmed differently. Read pages 8-9 before proceeding.
Complete each step within 60 seconds of completing the
previous step. If you don’t, you may start again at step 1.
1
Press the VCR button.
2
Press the TIMER button.
4
Use the Number buttons to enter the PlusCode
programming number of the program you wish to record.
(This number is different for every program.)
3
Press the PLAY 8 or STOP 9 button to select VCR
PLUS+, then press the FF :/OK button.
VCR PLUS+ PROG. CODE
VCR PLUS+ L
TO END PUSH EXIT
VCR PLUS+ PROG. CODE
VCR PLUS+ 1234L
TO SET PUSH :/OK
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
SELECT , 9 CHOOSE :/OK
A VCR PLUS+
QUICK PROGRAMMING
PROGRAM REVIEW
TO END PUSH EXIT
1
2
4
3
VCR TV
VCR/TV
QUICK PROGRAMMING
POWER
STILL/SLOW
EJECT
CH VOL
EXIT/STATUS
TIMER
JOG/SHTL
SMARTPICTURE INDEX AUDIO/MUTE
MENU
- +
CBL / DBS
1 2 3
4 5 6
7 8 9
START STOP DATE
DBS DAILY
PLAY
REW FF
/OK
STOP
WEEKLY
REV
/OTR REC REC
FWD
-
+
-
+
SPEED 0 CLEAR