Philips 4 HD S VHS HIFI VCR - Manual (Page 8)

ANT. IN
VIDEO
L
R
AUDIO
(MONO)
OUT IN
OUT IN
RF OUT
CH3 CH4
S-VIDEO
CABLE
BOX
LP 30561-003 75 Ω
ANT /
CAB LE
OUT
IN
8 Hookups with a Cable Box/Direct Broadcast System
Connections
1
Connect a Cable signal to the IN jack on the Cable Box/DBS.
2
Use an RF coaxial cable (supplied) to connect the OUT jack on
the Cable Box/DBS to the ANT(enna) IN jack on the VCR.
3
Use a second RF coaxial cable to connect the RF OUT jack on the
VCR to the TV’s ANTENNA IN jack.
Recording/Viewing Any Channel
1
With the VCR on and in VCR position (the VCR light will appear
on the display panel), use the CH(annel) 8/9 button to set the
VCR to the Cable Box/DBS output channel (channel 03 or 04).
2
Set the TV to the same channel to which you set the VCR. Set the
CH3/CH4 switch on the VCR to the same channel.
3
Select the channel you want to view/record at the Cable
Box/DBS.
1
2
There are two ways to connect your Cable Box/DBS to the VCR. With this connection:
• You may view any channel.
• You must select channels at the Cable Box/DBS. Channels cannot be changed at the VCR.
• You may not view a channel other than the one you are recording.
• You may not set up channels at the VCR.
• Timer recordings are programmed differently. Set the TV and the VCR to the Cable Box/DBS output
channel (channel 03 or 04); set the VCR’s CH3/CH4 switch to the same channel.
If you are not using the Controller, set your Cable Box/DBS to the channel you want to record. When you
enter the channel you want to record in a timer recording, select the Cable Box/DBS output channel (03 or
04). This is step 3 on page 40.
If you are using the Controller, enter the channel that you want to record at step 3 on page 40 (not the
Cable Box/DBS output channel). The Controller will select the channel at the Cable Box/DBS for recording.
3
Cable signal
RF coaxial cable
RF coaxial
cable
Cable Box/DBS VCR
TV’s
ANTENNA
IN jack