2GIG Z-Wave - Manual (Page 12)

10
Scenes & Rules
Controlling Multiple Devices
Beyond simple controlling of a single device,
multiple device control commands can be
assigned using a “ Scene”. A Scene can be run
on its own, or “ Rules” can be assigned to trigger
a Scene after a Control Panel “event” such as
arming your system or when an alarm occurs.
Creating Scenes
Scenes are created by assigning one or more
device actions to the Scene. The multi-function
Scene can then be easily executed by pressing
the Scene’s RUN button.
To create a Scene, use the following steps:
1. From the Home Screen press the HOME
SERVICES button.
2. From the Manage Z-Wave Devices Screen, press
the SCENES button.
3. From the Z-Wave Scenes Screen press the ADD
SCENE button.
4. Use the alphanumeric keypad displayed to enter
a name for the new Scene. Press OK when
fi nished.
5. Press the ADD button.
6. Press Z-WAVE SWITCH or Z-WAVE
THERMOSTAT to add one of these device types
as an action to the Scene.
Z-Wave Switches
7A. Use the
← or → arrows to choose a switch
device (if there is more than one device), then
select an ON, OFF, or a dimming level for the
switch. Press OK.
Z-Wave Thermostats
7B. Use the
← or → arrows to choose a thermostat
device (if there is more than one device), then
select a mode, setpoint, and fan setting for the
thermostat. Press OK.
✓ NOTE: The device will not activate while
setting Steps 7A & 7B. The scene must be
“run” or triggered by an event with a “rule”.
8. The assigned action(s) for the Scene will be
displayed. Repeat Steps 5 through 7 to add
additional actions to the Scene. Press BACK
when fi nished.
✓ NOTE: Only one action per device can be
assigned per Scene.
9. Test the Scene by pressing RUN. A Scene
execution confi rmation screen will be displayed,
press OK.
New Scene with Actions Screen
Create Action Screen
Press a device type
for the action
Scenes Screen with RUN Button
Press RUN button to
run the scene
New Thermostat Action Screen
Choose setpoints and
modes
New Switch Action Screen
Choose a device, then
set the action
Z-Wave Scenes Screen
Press ADD SCENE
button