Belkin Omniview SMB KVM-over-IP Switch F1DP108G - Manual (Page 22)

19
1
2
3
4
5
6
7
8
9
10
section
Local Installation
3.4 Connect the Switch to the Server Interface Module using the included
Belkin CAT5e Patch Cable or other CAT5 cable. (Refer to diagram
below.) Your server should recognize your Server Interface Module and
automatically install the HID USB driver if necessary.
;X`jp:_X`e :fejfc\
=C8J? C8E J<I@8C
>fCfZXc
3.5 Repeat steps 3.1 through 3.4 for each additional USB server you wish
to connect.
Note: We recommend you attach the Server Interface Module cable
directly to a free USB port on your server with no USB devices in between.