Belkin Omniview SMB KVM-over-IP Switch F1DP108G - Manual (Page 34)

31
1
2
3
4
5
6
7
8
9
10
section
Remote Installation
Step 3 Network Configuration
When first connecting to the Switch’s HTTPS configuration page, two browser
security warnings may appear. Click “Yes” on both warnings.
Device Name
Type in a name you would like to assign the Switch. The default device name
consists of the letter “D” followed by the 7-digit device number located on the
back of the Switch.
Required TCP Ports
Choose the “Transmission Control Protocol (TCP)” port, and type in the provided
field. The system will set two additional ports starting with the one provided.
The default ports are 900, 901, and 902. This is suitable for the majority of
installations. However, you can enter any value for TCP ports, from 800 up to
65535. For example, if you specify port 500, the system will use ports 500, 501,
and 502.
Note: Your firewall or router security access list must enable inbound
communication through the selected TCP ports for the Switch’s address.
Ports 80 and 443 are used for standard Web communication and should be
open. For client-computer access from a secured LAN, the selected ports
should be open for outbound communication.