Belkin Omniview SMB KVM-over-IP Switch F1DP108G - Manual (Page 40)

37
1
2
3
4
5
6
7
8
9
10
section
Remote Installation
To specify and name servers:
1. Click next to the Daisy-Chain field and select the KVM-switch
configuration that best suits your configuration.
2. Click . The number of possible connected servers will appear in the
Server Name section.
3. Change the name of each connected server by highlighting the server and
typing in a new name.
4. Click . to save the changes.
Note: You will need to change the name of every server you want to access.
Server names left as “
UNUSED” cannot be accessed.
Installing new Switch-Definition Files (SDFs)
If your switch-configuration type is not listed in the Daisy-Chain drop-down list,
contact Belkin Technical Support at (800) 282-2355 to request an updated SDF
with the desired KVM-configuration list.
To install the SDF:
1.
Load the file onto the client computer.
2. Click to locate the new SDF.
3. Click “Install” to update the Switch with the new file.
Note: If you change the hot-key sequence in the local OSD to
“Print Screen”, “Ctrl”, or “F12”, you must load a new switch-definition
file (SDF) for the corresponding hot key. The SDF can be downloaded from
www.belkin.com/support.