Belkin Omniview SMB KVM-over-IP Switch F1DP108G - Manual (Page 69)

66
Using the Switch from a Remote Console
Hot-Key-Command Shortcuts
Below is a complete list of hot-key commands that can be used for your Switch:
Command Function
Scroll Lock, Scroll Lock, è Switch to PREVIOUS ACTIVE port
Scroll Lock, Scroll Lock,
ê Switch to NEXT ACTIVE port
Scroll Lock, Scroll Lock,
Page Up
Switch to PREVIOUS BANK (By default,
selects first active port on the BANK)
Scroll Lock, Scroll Lock,
Page Down
Switch to NEXT BANK (By default, selects first
active port on the BANK)
Scroll Lock, Scroll Lock, Y
Directly switches to PORT Y on BANK 00
(single-switch configuration) (Y=01 to 16)
Scroll Lock, Scroll Lock,
Y, X
Directly switches to PORT Y on BANK X
(daisy-chain configuration) (X=00 to 15),
(Y=01 to 16)
Scroll Lock, Scroll Lock,
Space Bar, F10
Monitor DDC2 (identifies monitor settings)
Scroll Lock, Scroll Lock,
Space Bar
Activate OSD
Scroll Lock, Scroll Lock, F4
Enable AutoScan mode (refer to AutoScan
button)
Note: You will have approximately five seconds to complete each
hot-key sequence.