Lukas P 640 TG - Manual (Page 17)

17
CAUTION!
When connecting the hose assemblies, always ensure that the connection
components are not soiled; clean beforehand if necessary!
REMARK:
The devices can be equipped with different coupling systems. They usually
only differ with regard to the article number and not the designation.
It goes without saying that the coupling systems can also be re-equipped at a
later time.
The coupling system for the factory status of the equipment can be found in the
separate instructions for your unit in the chapter entitled "Technical data".
WARNING / DANGER / CAUTION!
Before connecting equipment, make sure that all the components
used are suitable for the maximum operating pressure of the
hydraulic unit! In cases of doubt, you must consult LUKAS
directly before connecting the equipment!
Connection of the hoses 7.
REMARK:
Before you want to connect hoses to and disconnect hoses from the hydraulic
unit as well as to couple and uncouple hoses with quick-disconnect couplings,
ensure that the actuating valves of the pump unit have been set at static pressure
or that the unit has been switched off or, in the case of electric pumps, has been
disconnected from the mains!