IKA C 200 - Manual (Page 9)

9
3 Transport, storage, place of installation
• The (constant) room temperature should be
around 20 °C ... 25 °C
• The system must be installed on a level surface.
• An adequate power supply corresponding to
the nameplates on the system components.
• Oxygen supply (99.95 % pure oxygen, quality
3.5; pressure 30 bar) with pressure display and
shut-off device (C 29 reducing valve, acces-
sories)
Make a note of any damage and report it imme-
diately (post, railway, shipping company).
1 x Power cable
1 x Operating instructions
1 x Water emptying hose (length: 1 m)
1 x Oxygen station C 248
1 x Measuring cup (2 l)
Please observe the respective country-specifi c re-
gulations for operating pressure equipment when
installing the appliance. A constant ambient tem-
perature is an important requirement for ensuring
the high measuring accuracy of the system. The
following conditions must therefore be fulfi lled at
the place of installation:
• No direct solar radiation
• No draughts (e.g. beside windows, doors, air
conditioning)
• Sufficient distance to radiators and other heat
sources
Please unpack the system components carefully
and check for any damage. When you unpack
the equipment, check for any damages which
may have occurred during transportation.
1 x Basic device C 200
1 x Decomposition vessel C 5010
1 x Ignition adaptor
1 x Attachment set
1 x Table power supply
3.1 Conditions of transport and storage
3.2 Place of installation
3.3 Unpacking
3.4 Delivery scope
• Only the original packing may be used for trans-
portation.
• The appliance must be completely emptied be-
fore storing and transportation.
• The system must be protected against mecha-
nical impact, vibrations, dust deposits and cor-
rosive ambient air during transportation and
storage.
• It is also important to ensure that the relative
humidity does not exceed 80%.