JLG 1500SJ Operator Manual - Manual (Page 32)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-4 – JLG Lift – 3121261
Pre-Start Inspection
The Pre-Start Inspection should include each of the following:
1. Cleanliness – Check all surfaces for leakage (oil, fuel, or bat-
tery fluid) or foreign objects. Report any leakage to the
proper maintenance personnel.
2. Structure - Inspect the machine structure for dents, dam-
age, weld or parent metal cracks or other discrepancies.
3. Decals and Placards – Check all for cleanliness and legibil-
ity. Make sure none of the decals and placards are missing.
Make sure all illegible decals and placards are cleaned or
replaced.
4. Operation and Safety Manuals – Make sure a copy of the
Operation and Safety Manual, AEM Safety Manual (ANSI
markets only), and ANSI Manual of Responsibilities (ANSI
markets only) is enclosed in the weather resistant storage
container.
5. “Walk-Around” Inspection – Refer to Figure 2-4.
6. Battery – Charge as required.
7. Fuel (Combustion Engine Powered Machines) – Add the
proper fuel as necessary.
8. Engine Oil Supply - Ensure the engine oil level is at the Full
mark on the dipstick and the filler cap is secure.
9. Hydraulic Oil – Check the hydraulic oil level. Ensure hydrau-
lic oil is added as required.
10. Accessories/Attachments - Reference the Operation and
Safety Manual of each attachment or accessory installed
upon the machine for specific inspection, operation, and
maintenance instructions. Parent Metal Crack Weld Crack