JLG 15/20MSP Operator Manual - Manual (Page 59)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121230 – JLG Lift – 3-33
Machine Tie-Down
With machine in position to be tied down and brakes engaged,
use the following guidelines for restraining the machine during
transport.
USE OF EXCESSIVE FORCE WHEN SECURING MACHINE (DRIVE WHEEL
LOAD), CAN CAUSE DAMAGE TO THE MACHINES DRIVE WHEEL COMPO-
NENTS.
1. Secure machine with an adequate chain attached through
the tie down loops located at the front and rear of machine.
(See Figure 3-6.)
2. The chain should be securely tightened with a force of
approximately 100 lb. applied two feet from the pivot handle.
Crane Hook Accessory (Option)
The crane hook accessory provides an attachment point for a lift-
ing device to lift the machine. The lifting device must be capable of
handling the gross weight of the machine, see the machine speci-
fications Section 5 of this manual.
DO NOT ATTEMPT TO USE THE CRANE HOOK ACCESSORY AS AN ATTACH
POINT TO LIFT ITEMS WITH THE MAST ASSEMBLY. THIS WILL RESULT IN
DAMAGE TO THE MAST AND POSSIBLE MACHINE TIPPING.
Figure 3-5. Crane Hook Accessory
1. Crane Hook Attachment 2. Back of Mast
1
2