JLG 15/20MSP Operator Manual - Manual (Page 71)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121230 – JLG Lift – 3-45
3.15 STOCK-PICKER HANGER ACCESSORY
NOTE: The stock-picker hanger accessory is available only on
the JLG MSP model and is not authorized for use with any
other JLG lift. This hanger accessory is intended for use
in placing or retrieving stock items such as bicycles, lad-
ders, etc., on racks or shelves above ground level. Use
for any other purpose is not authorized by JLG.
The hanger accessory is a pivoting arm mounted to the MSP plat-
form rail. The hanger accessory can be mounted to either side of
the platform individually, or two can be mounted, one on each side
of the platform. Each individual hanger has a maximum load
capacity of 100 lb. (45kg).
The hanger arm can be pivoted out of the way parallel with the
platform side rails when not in use, (the stowed position). The
hanger arm is pinned into position at 90 degrees to the platform
side rails when in use, (the carry position).
Pre-Start Inspection
Prior to use of the hanger accessory, check the following;
• Hanger arm mounting is secure to the platform railing, no
missing or damaged fasteners.
• The hanger arm lock pin is in place and secure.
THE COMBINED WEIGHT OF PERSONNEL, MATERIALS, EQUIPMENT PLUS
ANY LOAD ON THE HANGER ARM ACCESSORY MUST NOT EXCEED THE
MAXIMUM LOAD CAPACITY OF THE PLATFORM.
Loading and Transporting an Item using the
Hanger Accessory
Use the following steps as a guide when loading and transporting
an object with the hanger accessory arm.
1. Keep the hanger arm in the stowed position when not in use.
2. When ready to use, pull the lock pin from the stowed position
hole and swing the hanger arm into the carry position. Place
pin in the carry position hole locking the hanger arm in place.
3. Load the object onto the hanger arm and use the hanger arm
strap to secure the object during transport.
MSP MACHINE’S EQUIPPED WITH THE OBSTRUCTION SENSING SYSTEM
(OSS) OPTION – OBJECTS PLACED ON THE HANGER ACCESSORY AND
EXTENDING BELOW THE BASE OF THE PLATFORM MAY CAUSE AN OSS
DETECTION - SOUNDING THE HORN AND PREVENTING THE PLATFORM
FROM LOWERING. IF NECESSARY, REPOSITION THE OBJECT OUT OF THE
OSS DETECTION ZONE.