JLG 15/20MSP Operator Manual - Manual (Page 66)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-40 – JLG Lift – 3121230
Pre-Start Inspection
1. Electronic Module LED Indicator (a)
2. Detection Zone
3. Place a pad of paper or similar size object, 6
to 12 in. (15 to 30cm) individually beneath
each transducer to check detection.
NOTE: (a) The LED Indicator will flash when an
object is detected at each sensor. Remove
object and allow the LED to stop flashing
before testing next sensor.
Figure 3-10. OSS - Pre-Start Inspection of Operation.
1
2
3