JLG X20J Plus Operator Manual - Manual (Page 15)

There is a control position available only for scheduled and unscheduled maintenance opera‑
tions, placed near the electrical components compartment on the machine.
On the electric board protection there is an auxiliary connector for the connection of the
optional second remote control (see photo).
To enable this position, use the key selector placed on the base of the turret and connect the
optional second remote control to the machine.
Before proceeding with the connection, carefully read the paragraph regarding the use of
the optional second remote control.
This control position can only be used to carry out checks and maintenance on the machine.
Do not use this position to control the machine during normal operations.
Note: it is absolutely forbidden to move the machine from this position if one ore more
operators are in the basket.
X20JPR0020413
BOOM LIFT MODELS X20JPLUS
JLG
11
ATTENZIONE
FOTO 1 FOTO 2
OPTIONAL SECOND REMOTE
CONTROL CONNECTOR POSITION OPTIONAL SECOND REMOTE
CONTROL CONNECTOR
DANGER