2N Wireless 3G router 2N EasyRoute_old design - User manual, 1571 v1.06 - Manual (Page 15)

Mounting 2.3
15
Wall Mounting
The 2N ® EasyRoute cover backside is equipped with two wall-mounting holes.
Power Supply
2N ® EasyRoute is fed with 10–16V DC. Where a source other than the included power
supply adapter is used, the voltage range and polarity shown on the 2N ® EasyRoute
power supply connector have to be maintained
Warning
n Do not connect the power supply until the antenna is connected to
2N ® EasyRoute to avoid the GSM/UMTS module damage.
Restart (Reset) Button
The restart (reset) button is located to the left of the 2N ® EasyRoute power supply
plug. When pressed shortly, it restarts 2N ® EasyRoute. When pushed longer (10 s at
least), it resets 2N ® EasyRoute to default values (factory setup).
Tip
n You will find the default value setting useful, for example, when you
forget the password or the gateway IP address for your web interface
access.
Figure 2.4
2N ® EasyRoute
Wall Mounting