2N Wireless 3G router 2N EasyRoute_old design - User manual, 1571 v1.06 - Manual (Page 69)

Table of Programmable Parameters 3.2
69
Enable authentification
Enable/disable the use of another device-specifying parameter within the VRRP
network. Authentication is a sort of safety lock against unintentional misuse of
devices with identical IDs rather than a password or unauthorised access
prevention.
Password
Enter the VRRP device password. It is included in every VRRP packet transmitted
by the device.
Setting options: 1-8 alphanumeric characters
Advertisement interval
Set the interval for sending state notifications to IP address 224.0.0.18.
SNTP
SNTP (Simple Network Time Protocol) provides time synchronisation with the
selected server. A client supporting the SNTP only cannot be a server for other
clients.
Enable
Enable/disable the use of the NTP server as defined below.
Setting options: ON/OFF
Default setting: OFF
NTP server name
Enter the NTP server domain name or IP address.
Update period
Enter the synchronisation interval for the selected NTP server.
Setting options: 5-43,200 min
Current local time
If time synchronisation was successful, this item shows the local date and time.
The parameter cannot be configured. If the NTP server is not configured, the date
and time data are reset to Thu Jan 1 00:00:00 2009 after every gateway restart.
SSH - Basic
The SSH (Secure Shell) protocol provides encoded connection with the SSH-
supporting servers. 2N ® EasyRoute always works in the client mode.