2 troubleshooting, Troubleshooting 6.2 – 2N Wireless 3G router 2N EasyRoute_old design - User manual, 1571 v1.06 User Manual
Page 95
Troubleshooting
6.2
95
6.2 Troubleshooting
For tips for the solution of other potential problems see faq.2n.cz.
´
No LED is on after power up.
u Check the power supply.
´
2N
®
EasyRoute is not logging into the GSM network.
u Check the SIM card.
u Check the PIN.
u Check the antenna connection.
u Select a place with a good GSM signal.
´
The 2N
®
EasyRoute Internet connection has not been established.
u Check the setting of the APN assigned to the SIM card by the provider.
´
No tone can be heard after line off-hook.
u Check the telephone line connection.
u 2N
®
EasyRoute has not been initialized properly (approx. 10 s after
power up).
u 2N
®
EasyRoute is not supplied with power.
´
2N
®
EasyRoute is ignoring the user dialling, transmitting the dialtone.
u Select the correct dialling type (DTMF/pulse).
u Adjust the width of the dialling pulses.
u Adjust the delay value between the pulses.
´
2N
®
EasyRoute is not communicating with the PC.
u Check the Ethernet cable connection.
´
Do you need to set some functions 2N
®
EasyRoute?
u Try to find help on HOW TO manuals. Current and new manuals can
always be found o