2N Lift emergency phone 2N LiftNet - Manual, 1446 v1.8.3 - Manual (Page 46)

Lift Cabin Audio Unit
– Compact
2.3
46
Mounting Completion
– without Rear Access
1. Insert the hex wrench
(included in the delivery) in the
bottom unit edge hole; turn left
about 10 times until it puts up
resistance.
2. The window slides down by
itself or with little assistance,
showing its upper brim.
3. Tilt the window forwards
and remove.
4. Now you have access to two
holes in the window corners.
Put unit (including the
connected wires) on the pre-
drilled lift cabin wall. Drive and
tighten the included screws for
plywood, chipboard, laminated
plastic etc. wall mounting or
short M4 screws with fan-
shaped washers (intended for
metal plate mounting with pre-
drilled M4 threaded holes).
5. Replace the window.
6. Insert the hex wrench
(included in the delivery) in the
bottom unit edge hole, turn
right about 10 times until the
window slides under the panel
edge and tighten applying light
force.