How to record user messages and numbers – 2N Lift emergency phone 2N LiftNet - Manual, 1446 v1.8.3 User Manual
Page 65
Parameter Chart (FW v. 1.8.0)
3.2
65
How to Record User Messages and Numbers
From a PC
To upload the user messages and numbers into the 2N
®
LiftNet device, you will need
the Service Tools utility. To upload a message into 2N
®
LiftNet, please follow the three
easy steps below:
1. Record your message using your PC soundcard and microphone. Save the
voice message to the .wav file with the following parameters: 8bit, 8 kHz,
MONO.
2. Upload the .wav files you have created into 2N
®
LiftNet using the Service Tools
via the Device / User Messages Upload or User Numbers Upload menu.
3. Remember to enter all of the 10 (0 – 9) .wav files while uploading user
numbers.
From a Telephone
Recording of a message from a telephone is possible during programming only (refer
to the Configuration section). Message recording is password protected. The record
quality depends on the phone quality and surrounding noise.