2N Lift emergency phone 2N LiftNet - Manual, 1446 v1.8.3 - Manual (Page 72)

Dispatching Centre Instructions 4.2
72
Setting Machine Room Audio Unit Number
Enter # before the lift number to set the machine room number.
For example, 011 - #8 means that calling to lift 8 machine room audio unit is set in
ALARM button memory 1.
Setting options:
1. Service Tools – enter # and lift number into parameters
011-016.
2. Set the lift number into the button memory (011-016) in
the programming menu, select parameter 017 (refer to
the table of parameters) and enter the required character
(#) into the appropriate button memory.
Caution
 The dispatching-intercom audio unit is set as lift 8 type machine
room by factory default.
 You can set alarm-intercom for lifts 1-7 too. All you have to do is change
the lift address (jumper) and set another number into the ALARM button
memory.
 The dispatching centre audio unit must be of the machine room
type and set as the machine room. If it is set otherwise (as a shaft,
cabin or roof), no call to the unit will be successful.
Note
 It is possible to combine calling to the machine room (dispatching) audio
unit with calling via the PSTN.
 To set up a checking call to a machine room audio unit, you can set the
number as described in the Alarm – Intercom subsection above.