2N Lift emergency phone 2N LiftNet - Manual, 1446 v1.8.3 - Manual (Page 60)

Parameter Chart (FW v. 1.8.0) 3.2
60
Par.
No.
Parameter Name Range Default Note
076
Checking call
memory 6 up to 16
digits 0 - 9
blank
077
Adding of a special
symbol *, # and
“delay”
078
Count of automatic
dialling cycles for
checking call
0 - 9 3
079
Automatic dialling
type
for checking call
0 - 3 1 see parameter 019
906
Delay after digit
dialling cannot be
changed
100ms
The parameter cannot be changed. It gives the
delay between the digit dialling and voice
message start.
909
Timeout for dialling
tone detection 1000 –
9999 ms
5000 ms
LN waits for the dialling or continuous tone for
this period of time. If it fails, the line is
defective.
911
Count of rings before
incoming call
answering
1 - 9 2
Defines the moment of picking up (for incoming
calls).
912 Max. call duration
10 – 1000
s
120 s Call can be prolonged by command.
913
Timeout for call
confirmation 10 – 1000
s
60 s
LN waits for confirmation for this period of time
(outgoing call, automatic dialling with come
confirmation enabled).
If it fails, LN hangs sup and proceeds to the
next number. Measured from the dialling end.
914 Delayed call 0 – 1000 s 0 s
Applicable only if the CANCEL input is used
(913610E unit only).
915
Max. TRIPHONY
duration 10 – 9999
s
7200 s
917
On-hook time
between calls 500 –
9999 ms
5000 ms
918
Max. time of
telephone line test
1 – 20 s 5 s
A line test (dialtone test) is made every 11
minutes. If the dialtone is missing in three
subsequent tests, the lift gets blocked. When
the line is recovered, the lift gets unblocked
automatically.
920
Call confirmation
command cannot be
changed
1 Mutes the message too.
921
Message muting
command cannot be
changed
2