2N BRI Lite/Enterprise v1.2 - Manual (Page 21)

21
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Ethernet Cable Connection
To connect into the Ethernet network, use a standard 2N BRI Enterprise/Lite
®
straight cable terminated with RJ–45 connectors (included in the package). The GSM
gateway supports the 10BaseT and 100BaseT standards, the Ethernet connection
status is indicated by the status LED indicators located on the RJ–45 connector (refer
to
for details). S. 2.1
Caution
The Ethernet interface is used for remote supervision and
configuration only, i.e. does not contain the VoIP interface.
With a proper licence, the device provides the VoIP–SIP support.
RJ–45 LAN Connector
NT and TE Connectors
1 not used2 not used3 Tx4 Rx5 Rx6 Tx7 not used8 not usedISDN devices are
connected to the NT/TE connectors depending on the configuration of your
telecommunications equipment. They are connected via a 4–wire passive bus with the
aid of RJ–45 connectors. Refer to the figure below for the NT/TE connector pin lay–out.