2N BRI Lite/Enterprise v1.2 User Manual
Page 55
55
Number
Meaning
OFF
Progress element is not sent in the message
1
Connection is not end–to–end ISDN, following progress messages will be
sent in the speech band
2
Call destination address is not ISDN
3
Call initiator address is not ISDN
4
Call is returning to ISDN
8
Communication between interconnected systems has lead to a change of
the telecommunication service (for end–to–end ISDN connection only)
10
Delay due to speech interface
BRI functions
Day of deleting statistics on BRI (every month) – set this item to '0' to disable
periodical (monthly) deleting of statistics. Set this value to 'x' other than '0' to
enable deletion of statistic data on x–th day of a month.
Digits count in SETUP (en–block) – set the count of outgoing dialling digits to be
sent by the gateway in the SETUP message in the ENBLOCK format. The
remaining digits will be sent in the OVERLAP format, i.e. in the information
element following the SETUP message. The OVERLAP mode is used in analogue
networks.
Example:
SETUP digit count: 7, user number: 601234567
Call setup messages:
SETUP (601234567)
INFO (6)
INFO (7)
Receive dial number from Subaddress – use this parameter to receive dialling
from the subaddress element instead of standard CDN.
Don't send Connect ACK on TE – use this parameter to enable/disable sending of
the CONNECT ACK message to the TE port.
Tone signalling for calls from ISDN
Dial tone to BRI1 with empty SETUP – set the dial tone type to be generated by
the BRI gateway.
Ring tone – set the ring tone type to be generated by the BRI gateway.
Generate busy tone to BRI1 – set the busy tone type to be generated by the BRI
gateway into the BRI 1 interface.
Generate busy tone to BRI2 – set the busy tone type to be generated by the BRI
gateway into the BRI 2 interface.
Numbering plan settings
CDN, CGN – use these parameters to set the
for the called (CDN) and
Numbering plan
calling (CGN) numbers.