Tracing commands – 2N BRI Lite/Enterprise v1.2 User Manual
Page 78
78
Routing Parameters
%A##=clip,dial,limit
...set autorouting item (ix 0..95)
clip (20), dial(20),
limit(0=off,1..99 minutes)
%R##=net,hh:mm/hh:mm/w+–,groups,lim
...set lcr–routing item (ix 0..63)
net (1..8), groups = (max 7
chars=1..3,9), 3=any module,
9=bri2
call limit (0=off, 1..99min)
last LCR table line must be empty
; totals
; first m,c,s
...inc. minutes,calls,smses
; second m,c,s
...out. minutes,calls,smses
; ri,ro
...redirected inc,out calls
%TB#=m,c,m,c
...init minutes,calls in bri #
(0..65535)
%TBALL=m,c,m,c
...init minutes,calls in all bris
(0..65535)
%TG#=m,c,ri,ro
...init minutes,calls,rin,rout in
group # (0..65535)
%TGALL=m,c,ri,ro
...init minutes,calls,rin,rout in all
groups (0..65535)
%TI#=m,c
...init minutes,calls in inc.group #
(0..65535)
%TIALL=m,c
...init minutes,calls in all
inc.groups (0..65535)
%T##=1,m,c,s,m,c,s
...init minutes,calls,sms in mod
##, sim 1 (0..65535)
%TALL=1,m,c,s,m,c,s
...init minutes,calls,sms in all
mods, sim 1 (0..65535)
Tracing Commands
AT!RE Start tracing of error messages active interface.
AT!Lx
Start tracing of LAN & Telnet on layer xx=2 – Layers IP,TCP,Telnet x=3 –
Layers TCP, Telnetx=4 – Layer Telnet
AT!Rx
Start tracing of ISDN BRI & GSM on layer xx=1 – Layers 1,2,3,4x=2 – Layers
2,3,4x=3 – Layers 3,4x=4 – Layer 4
AT!RR Start tracing (AT!R2) to COM1 interface
AT!RX Stop tracing (AT!R2) to COM1 interface