2N NetStar Assistant manual - Manual (Page 90)

90
Assistant HTTP port – specify the port on which your 2N NetStar Assistant
®
is working if you do not use default settings.
Get method – select the preferred method: either
or . HTTP HTTPS
Run command – specify in which browser should be 2N NetStar Assistant
®
launched by the left mouse-click on the Tray launcher.
PBX IP address – enter your IP address as advised by your 2N NetStar
®
network administrator.
PBX bridge port – this parameter cannot be set. It specifies the library
communication port for PBX communication. This port must be allowed if you use
the NAT between the PC and the PBX.
Add DID – before numbers with min length – these parameters are tied
together. They specify the DID to precede numbers with minimum length
replacing the prefix used in the PBX.
Suppose your PBX DID to the GSM network is '0'. Set the Tray
launcher to pre-dial '0' for you. Enter '0' into the
field and '9' Add DID
into the numbers with min length. Now you can call GSM numbers
from the Tray launcher as follows: you dial 777515668 but
0777515668 will be actually dialled.
KeepAlive packets – specify whether or not the KeepAlive packets should be
sent.
Timeout (ms) – set the time interval between the KeepAlive packets.