2N VoiceBlue Next v3.0 - Manual (Page 56)

Web Configuration Interface 3.4
56
 Text of SMS at no answer – type the text of the SMS to be sent to the called
subscriber in the event of no answer (+ the function is active). The %N string
inserts the CLIP received from VoIP into the SMS.
 Text of SMS for all calls - fill in this parameter to make the GSM gateway send
an SMS message to every called subscriber regardless of whether or not the
call was connected. The %N string inserts the CLIP received from VoIP into
the SMS.
 Save received SMS to - select the storage for SMS received.
 SIM card identification – select the SIM IMSI/SCID for CDRs.
 Disable CLIP from GSM/UMTS to VoIP - enable/disable resending the CLIP
from GSM to VoIP.
 Reject call with CHLD – reject incoming GSM/UMTS calls by means of
AT+CHLD (user busy) instead of standard ATH.
GSM group assignment
You can assign the GSM/UMTS modules to groups separately for incoming and
outgoing calls. See the two items below for outgoing and incoming group
settings.
GSM outgoing groups
2N ® VoiceBlue Next allows you to work with two groups of outgoing calls for each
of which you can set variable connection set-up modes and count of used minutes
and sent SMS messages for a selected period.
General settings
 Delay for CONNECT [s] - define a delay before sending information on the
connected call after receipt from GSM.
 Minimum ring duration to send SMS at no answer [s] - set the minimum
ringing time for an outgoing call to GSM/UMTS before the SMS at no answer is
sent.
Note
 The SMS at no answer function works properly only if the INVITE
message contains the called and caller numbers.
 Delay for ALERTING [a] - define a delay before sending information on ringing
start.
 Minute parameter - select whether or not the GSM gateway should record the
call length or count for outgoing call restriction.
 Day of deleting statistics in group (every month) - define a day on which
statistics on disconnected calls should be deleted.
 Generate virtual ring tone - enable/disable generation of the virtual ringing
tone to the VoIP interface.
 Call length counting: select whether the call should be counted in seconds or
minutes.