2N VoiceBlue Next v3.0 - Manual (Page 57)

Web Configuration Interface 3.4
57
 BTS lock – identify the BTS to which the GSM modules should be logged
fixedly. Restart the selected GSM modules to execute the changes.
Caution
 The BTS lock service works with specific GSM modules only (Q55)!
 An error in BTS identification results in a GSM module login failure.
 After call relax delay – interval between the current call termination and next
call setup via the same GSM/UMTS module. 2 seconds is recommended for
high-traffic installations.
Disconnect call
Specify the reasons for an immediate disconnection of an outgoing GSM/UMTS call.
Send CLIP from VoIP to GSM/UMTS
 Transfer CLIP to GSM/UMTS - enable/disable the function.
 Separating char - the CDN / CLIP separating character.
 Modify („-‟ removes one digit) - you can change the CLIP. The „-‟ character is
used for deleting one char from the left.
Caution
 The Send CLIP from VoIP to GSM service must be supported by the
GSM/UMTS provider. If not, the provider‟s network may reject the call!
Basic settings
 Roaming enabled for network code - set the international network identifier
for roaming purposes consisting of the following two codes:
o MCC – Mobile Country Code – country code (Czech Republic - 230);
o MNC – Mobile Network Code – GSM code (T-Mobile - 01, 0202,
Vodafone - 03).
Hence, the international identification code for T-Mobile CZ is 23001.
Leave this field empty to disable roaming.
String Note
<empty> Roaming is disabled
2300 Roaming is disabled (5 digits is the minimum count)
23002 Roaming is enabled for networks with MCC+MNC code 23002
230XX Roaming is enabled for networks with MCC+MNC codes 23000 – 23099
XX001 Roaming is enabled for networks with MCC+MNC codes 00001 – 99001
XXXXX Roaming is enabled for any network