2N VoiceBlue Next v3.0 - Manual (Page 74)

LOGs 4.3
74
4.3 LOGs
For the current LOG records see the Gateway / Gateway control – LOG file section
or use the AT&L AT command for Telnet sessions. The following list of LOG statuses is
universal and some LOGs may not be included in 2N
® VoiceBlue Next:
Type Text Description
POWER [Power on] System switched on
[Power off] System switched off
[Warm boot] Restart of system, unknown cause
[Watchdog] Restart of system by watchdog
[BKPT code] CPU error: break code detected
[Stack error] CPU error: stock integrity failure
[Divided by zero] CPU error: dividing by zero
[RETI code] CPU error: illegal using of instruction reti
[NMI intr] CPU error: wrong interrupt
[VOID intr] CPU error: wrong interrupt
[Upgrade reset] Start of upgrade firmware procedure
[Software reset] Reset by AT commands (at&fres…)
INIT Eeprom Initialisation of eeprom (configuration)
Flash Initialisation of flash memory (firmware)
HW-ERR (##…address of chip, RD…read value/WR…expected value)
Codec ##,RD/WR Error in initialisation of codec on GSM,AUX board
COM2 #####,RD/WR Error in initialisation of COM2 on AUX board
Duart #####,RD/WR Error in initialisation of serial controller on GSM board
Hscx #####,RD/WR Error in initialisation of HDLC controller on AUX board
Pri #####,RD/WR Error in initialisation of PRI controller
SYSERR User stack error! SW error: stock integrity failure
BRDIN #08 TYP STS Board inserted (number of gsm board, type, status)
BRDOUT #08 TYP STS Board disconnected
BRDRES #08 TYP STS Reset the board by AT command
ALL GSM RESET CMD Reset all GSM boards by AT command
SYSTEM RESET CMD Reset the system by at&bsys command
L1-ERR (reserved)
L2-ERR Error of ISDN layer 2 by Q.921
A: unsol.RX(F) Received packet RR,RNR,REJ with unexpected bit F=1
B: unsol.DM(F) Received packet DM with unexpected bit F=1
C: unsol.UA(F) Received packet UA with unexpected bit F=1
D: unsol.UA(-) Received packet UA with unexpected bit F=0
E: unsol.DM(-) Received packet DM with unexpected bit F=0
F: peer re-est Received packet SABME in status OKEST
G: repeated SABME Repeated unsuccessful send of packet SABME