AirLive Ether-GSH2416W - Manual (Page 19)

19
2.4.2 802.1Q VLAN Configuration
IEEE 802.1Q (tag-based) VLAN can add or strip 802.1Q tag depending on the requirements of the
individual transmitting port. It is required to click the VLAN menu item to set the VLAN type to
IEEE 802.1Q VLAN in VLAN Configuration page before doing the advanced configuration.
Click the Configure button to open the configuration page after the IEEE 802.1Q VLAN type is
activated (shown as figures below).
The group with VLAN ID 1 stands for the default 802.1Q VLAN group. This default group can’t be
deleted. However, the port members in this group can be modified. In default setting, all 24 ports are
the untagged members of this group with port VID value 1. Currently this system supports up to 32
tag-based VLAN groups for manual entry.
NOTE: Please be aware that this system currently has a constraint for web configuration in
802.1Q VLAN environment. This switch doesn’t allow web configuration from multiple VLAN
groups. That is, web configuration can be done through ONLY ONE specified VLAN group
(default VLAN group with VID=1 in default). Specify one VLAN group (e.g. VID=2) for
allowing to web-manage the switch and use console to set the PVID value (e.g. PVID=2) for
admin port (Port25), then web management can be achieved only through VLAN group
members with VID=2.