AirLive Ether-GSH2416W - Manual (Page 54)

54
2.13 Command Line Interface (CLI)
In addition to the web management, the Ether-2416W web smart switch also provides a serial
interface (RS-232) as a console port on the rear panel to manage switch for system setup, user
management, reset system and firmware update through the command line interface (CLI). Windows
Hyper Terminal is recommended to use. This section will show how to setup and use Hyper
Terminal to manage this switch.
2.13.1 Hyper Terminal Setup Options
„ Baud Rate：19200 bps
„ Data Bits：8
„ Parity：None
„ Stop bits：1
„ Flow control：None
2.13.2 Switch Management Commands In Console
„ Login System
After the system started, the following prompt will displayed on Hyper Terminal. User
needs a valid username and password to login this system. The username and password in
CLI are the same as the ones using for login access through the web page. Please enter
correct username now.
After enter the username, the following prompt will be displayed. User should enter the
correct password now, and then manage the Ether-2416W web smart switch.