AirLive Ether-GSH2416W - Manual (Page 53)

53
2.12 Reboot / Reset System
This switch can be rebooted or reset to default configurations through the web page for your request.
Go to the Reboot/Reset menu item to open the Reboot/Reset System page for this action.
Click the Reboot button to reboot this system. The configurations will be retained to the same as
before reboot procedure.
If this system’s configurations need to be reset to default (factory) values, press the Reset to Default
button to start the procedure. System will be automatically rebooted after configurations are already
reset. All configuration changes before the reset procedure will be lost.
The Ether-2416W web smart switch also provides an alternative to do Reset System by using the
Reset button on the rear panel:
¾
While the system is running (the DIAG LED indicator is ON), pressing and holding the Reset
button (over 5 seconds) until the DIAG LED indicator is starting to flash at any time will
activate the Write Default procedure.
After the procedure mentioned above is done, the switch will be rebooted and initialized using the
default settings automatically.
The time of system rebooting will take about 10 seconds. You need to login the system again to enter
the web pages for continuous configurations.