AirLive Ether-GSH2416W - Manual (Page 9)

9
2.2 Port Configuration
If you need to do the port configuration, just select one desired port by clicking the Port number in
the Port Status page. Then the Port Configuration page (shown as below) for the selected port (e.g.
port3) will be opened:
The following parameters will be provided and configured in the Port Configuration page:
„
Port – the selected port number to be configured (read only)
„ Admin – to unblock/block the traffic for the port
¾ Disable – to block all traffic for the port
¾ Enable – to enable the bi-directional traffic for the port
„ Auto Negotiation – to enable/disable the capability of auto negotiation for setting up the link
¾ Disable – to disable for the port (force mode)
¾ Enable – to enable for the port (auto mode)
„ Speed / Duplex – to setup the link speed and duplex mode in force mode
The options for this function can be selected only when the Auto-Negotiation is Disabled (in
force mode) for copper ports (Port17 to Port24). At this moment, there are 4 options for this
parameter:
¾
100Mbps Full – to set the speed 100Mbps in full duplex mode
¾ 100Mbps Half – to set the speed 100Mbps in half duplex mode
¾ 10Mbps Full – to set the speed 10Mbps in full duplex mode
¾ 10Mbps Half – to set the speed 10Mbps in half duplex mode
The following figure shows the options of Speed / Duplex while Disable is selected in
auto-negotiation field for copper port (e.g. Port17).