AirLive Ether-GSH2416W - Manual (Page 6)

6
1.1 Start to Manage This Switch
Plug-in the power source to power-up the switch. After the switch is powered-on and in ready state
(both the LED indicators POWER and DIAG are lighting), you can use any in-band Ethernet port to
remotely manage this system through the web browser, or use the RS-232 cable to plug-in the
console port (on the rear panel) to locally do the simple system configurations by using the
command line interface (CLI). The default IP and related settings for this interface are shown as
following:
„
IP address: 192.168.223.100
„ Network mask: 255.255.255.0
„ Default gateway:192.168.223.254
Try to use the default IP shown above to PING the switch from your PC to make sure the network
connection is successful. The default IP address on this switch can be modified later for your need. If
you encounter the access problem by using wrong IP addresses, just locally connect to console port
to get the correct IP address in this system.
Now you can use the browser to start to launch to the user-friendly web-managed interface for this
switch.
The login dialog box (shown as below) will show up first when the switch’s IP address is provided
through your browser.
Use the default username and password shown as below to complete the login procedure:
„
Username: admin
„ Password: 123
This username/password can be modified for your need.