AirLive RS-3000 - Manual (Page 26)

Adding Multiple Subnet
Add the following settings in Multiple Subnet of System function:
 Click on New Entry
 Alias IP of LAN Interface： Enter 162.172.50.1
 Netmask：Enter 255.255.255.0
 WAN1: Choose Routing in Forwarding Mode, and press Assist to select Interface
IP 60.250.158.66.
 WAN2：Enter Interface IP 211.22.22.22, and choose NAT in Forwarding Mode
 Click OK
 Complete Adding Multiple Subnet (Figure 4-8)
Figure 4-8 Add Multiple Subnet WebUI
WAN1 and WAN2 Interface can use Assist to enter the data.
After setting, there will be two subnets in LAN: 192.168.1.0/24 (default LAN subnet) and
162.172.50.0/24. So if LAN IP is:
192.168.1.x: it must use NAT Mode to access to the Internet. (In Policy it only can setup to access to
Internet by WAN2. If by WAN1 Routing mode, then it cannot access to Internet by its virtual IP)
162.172.50.x: it uses Routing mode through WAN1 (The Internet Server can see your IP 162.172.50.x
directly). And uses NAT mode through WAN2 (The Internet Server can see your IP as WAN2 IP)
24