Atop Technology AW5500C User manual - Manual (Page 15)

Atop Industrial Wireless Access Point
AW5500C
User Manual V. 1.0
10
3.3 First Time Installation
Before installing the device, please adhere to all safety procedures described below, Atop will
not be held liable for any damages to property or personal injuries resulting from the
installation or overall use of the device. Do not attempt to manipulate the product in any
way if unsure of the steps described here, in such cases please contact your dealer
immediately.
 Prepare the necessary cables, DC adapter, power cord, LAN cable, etc.: do not connect
the unit yet.
 Install the antenna to the SMA connectors.
 Proceed then to plug the power source to the unit, starting from the ground and then the
terminal block.
 Place the device in the desired location and connect it to the LAN via an Ethernet cable
with a RJ45 connector.
 Connect your computer to the LAN network. Default configurations will be addressed
later on Sections.
Note: remember to please consult your Hardware Installation Guide when attempting an installation. Also, please
follow all safe procedures when doing so.