Atop Technology AW5500C User manual - Manual (Page 72)

Atop Industrial Wireless Access Point
AW5500C
User Manual V. 1.0
67
4.13 Reboot and Restore Default Settings
To manually reboot the device, you may click on “Reboot”, after which the device will restart. If
a factory default setting is needed, tick the “Reset” checkbox, and then click on Reboot, Figure
4.45. Also, you could use the button located on the Front panel, close to the LAN Port; it is
conveniently labeled as Reset. Just insert the tip of a paper clip and hold it long enough until
the device produce a long beep, release the button and wait for the device to restart.
Figure 4.45