Atop Technology AW5500C User manual User Manual
Page 75
Atop Industrial Wireless Access Point
AW5500C
User Manual V. 1.0
70
Steps for a quick setting for the AW5500C as a Regular AP are:
On operation mode choose
“Regular AP” (if the device is not in factory default).
Go to
Wireless → Basic Settings; here you can change the Network Name (SSID) to
your preferred name, you might want to first click on
“Scan network” to find whether
there are neighbors with a name matching yours (this is done for preventing any conflict
over networks).
At this point you may decide to change other settings such as the Wireless Mode and
whether to have Automatic Channel Selection.
Next go to Security Settings, and on Security Mode choose which security protocol will
be used in the network. We strongly recommend not leaving this section as disabled.
On LAN & WLAN Interfaces, enter the IP Address, Subnet Mask, Default Gateway,
and DNS servers used (if any), according to your network configuration.
Click
“Apply”, and wait for the changes to take effect. You may also want to Save
Settings afterwards just in case you need these configurations in the future.