Atop Technology SE5001A User manual - Manual (Page 17)

User Manual Version 1.0
SE5001A Serial Device Server
15
3.1 Configuration by Serial Manager
SE5001A could be configured by Serial Manager, for more information, refer to Serial Manager’s manual.
3.2 Configuration by Telnet Utility
You can use a Telnet utility to change configuration settings of SE5001A by following steps：
3.2.1. Login to the System
->Open MS-DOS command prompt window or any other telnet application
->Telnet to SE5001A using command “telnet IP_address”. (For example：”telnet 10.0.50.100” in MS-DOS
command prompt window). After telnet into SE5001A, system will prompt for a password, the default password is
blank. (Figure 3.1)
Figure 3.1 Login to the system
Note: Press the default button of SE5001A to reset the password to the default value.