Atop Technology SE5001A User manual - Manual (Page 42)

User Manual Version 1.0
SE5001A Serial Device Server
40
3.3.14. TCP Client Application: Configure SE5001A as a Pair Connection Slave
A Pair Connection Slave (Figure 3.29) needs to pair up with a Pair Connection Master. Please setup a Pair
Connection Master first before proceeding.
Figure 3.29 TCP Client with Pair Connection Enabled
 Follow section 3.2.6 to configure SE5001A in TCP Client mode properly.
 Check Enable Pair Connection to enabled Pair Connection application in SE5001A.

Scroll to the bottom of the page and click on “Save Configuration” button to save the changes.
 Match the Destination IP and Port here with the settings of Pair Connection Master’s IP and Listening
Port setup previously.