Atop Technology SE5001A User manual - Manual (Page 63)

User Manual Version 1.0
SE5001A Serial Device Server
61
4.5 Serial/IP Advanced Settings
In the Serial/IP Control Panel, Click on the Advanced button to open Advanced Settings window (Figure 4.18). Click
on Use Default Settings to load the default settings.
Figure 4.18 Serial/IP Default Advanced Settings
 Extend Server Connection
Maintains the TCP connection for specified amount of time after COM port is closed
 Attempt Server Connection
Terminates pending connection attempts if they do not succeed in the specified time
 Synchronize with Server Upon COM Port Open
Required by NT Systems (2000, XP, Vista, 7)
 Update Routing Table Upon COM Port Open
Maintains IP route to a server in a different subnet by modifying the IP routing table
 Enable Nagle Algorithm
Provides better network efficiency by imposing a minor latency on the data stream while it waits to fill network
packets
 Always Limit Data Rate to COM Port Baud Rate
Limits the data rate to the baud rate that is in effect for the virtual COM port