Atop Technology SE5001A User manual - Manual (Page 18)

User Manual Version 1.0
SE5001A Serial Device Server
16
1. After verifying the password, the following terminal screen appears (Figure 3.2).
Figure 3.2 Main menu
Note
1. If SE5001A does not receive any commands within 1 minute, Telnet connection will terminate automatically.
2. After “0. Exit” is selected; the console will ask the user to save the configurations.
3. Changes to networking parameters will take effect only SE5001A is restarted.
-> Select “1” from “Input choice and enter (0~4):” to enter “Overview” (Figure 3.3):
Figure 3.3 Overview
This page gives one the general information of SE5001A including IP and MAC address, SNMP information, kernel
and AP version, and connection status of the device.