Atop Technology SE5404D User manual - Manual (Page 15)

User manual Version 1.3
4-Port DIN-Rail Serial Device Server SE5404D
Copyright © 2011 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
- 14 -
Blinking AP firmware is running normally
2.2 Installation Procedures
Step 1: Connect SE5404D to power source
Step 2: Connect SE5404D to the Ethernet network. Use a standard straight-through or cross-over Ethernet
cable Always make sure the PC is on the same network subnet as SE5404D.
Step 3 : Connect SE5404D’s serial port to a serial device.
Step 4: Mount SE5404D to a Din Rail.
Attention
Disconnect the device from power source completely before installing and wiring
the server.
Do not exceed the maximum allowable current of the power cord and common
wire. Applying the wire over its specification would cause the wire to overheat and
cause serious damage to the connected and neighboring equipment.
The casing could become too hot to touch when operating in harsh environments.
Please handle with care.
RESTRICTED ACCESS AREA: The equipment should only be installed in a
Restricted Access Area.