ETC Cobalt Family v7.1.0 - Manual (Page 588)

Cobalt 7.1 - 20140612
587
Device Control - Align
The Align key in the programming section copies parameters from one Device to several others.
1. Select all involved devices, including the one you want to copy parameters from
2. Use
Next/Last to select the device you are copying from
3. Hold ALIGN and then press the key corresponding to the parameter or parameter group you
want to copy:
Function Key Feedback
Align FOCUS [ALIGN] & [FOCUS] All Focus parameters are
copied*
Align COLOR [ALIGN] & [COLOR] All Color parameters are
copied*
Align BEAM [ALIGN] & [BEAM] All Beam parameters are
copied*
Align single parameters [ALIGN] &
[Wheel_Key] The parameter assigned to
the wheel is copied.
*If Palettes are used, the palettes will be aligned, not the values.