ETC Cobalt Family v7.1.0 - Manual (Page 597)

Cobalt 7.1 - 20140612
596
Displays
The parameters are definable in the Device Mode settings.
In Cobalt 10: Press RANGE to the other upper/lower bank.
Device Mode Settings
You can define the parameters in Device Mode in two ways.
• Assigning them directly by holding a parameter wheel key and pressing a master key. See
Masters - Attribute parameters
• In the Device Mode Parameters setup.
Hold SETUP and press DEVICE to open the Device Mode settings.
You can define which parameters that are mapped to the pots in Device Mode here.