ETC Cobalt Family v7.1.0 - Manual (Page 593)

Cobalt 7.1 - 20140612
592
Device Control - Flip
If a moving head reaches its end position for Pan - it is possible to press FLIP to invert the pan and tilt
values so that the end position is "passed". Observe that the result of a flip depends on the pan range
of a device, and will not always be the same position as before the flip.
( Soft Key Pages are commands in the lower right corner of screen 2)
Select the device(s) you wish to flip, and press FLIP. To undo press FLIP again.